Stand-alone Proximity Access Control With Built In Cardreader

• Single door proximity system
• Maximum reading range from 5.5"-7.9" (under normal environment)
• Data is protected even after power failure
• Programmable alarm loop enable/disable through command code
• Access code could be added or deleted through command code
• 3 operating Modes Card only, Card with Keypad or free access mode (Facility Code only)

This system uses the transponder technique, which means that the exchange of data between the badge and the reader is carried out via a magnetic field (without physical contact). The reader is also equipped with a keypad, allowing conventional use of the device.
Frequency: 125kHz, could be used by: 0.07"-0.03" EM card or key tag, card capacity: 9999 cards (key tags). Built-in tamper switch: detects when case is forced open or destroy (Alarm signal output (A.B. point)). Programmable door release time from 1~250 seconds through command code
Keypad: 3 x 4 keys, power requirement: DC 12V 1A, operating temperature: 32°F to 122°F, humidity: 20% to 90% RH, dimensions: 5.1" x 3.4" x 1.0", relays: 2 relay contacts (max. DC 12V 1A)